record
Mark Huntsman providing tech tips from the Recorducation studio
Mark Huntsman providing tech tips from the Recorducation studio

Recorducation Videos

Wondering how to rehand a Record swing operator in the field? Having trouble wiring an electric strike? We've got you covered. Check out our list of helpful videos below. Is there a topic you'd like us to cover? Send us an email.

General Topics

  • I-Record Intro

Swing Doors - 8100/SimpleSwing

  • How to properly preload and install a standard arm

  • How to properly preload and install a track arm

  • Wiring your wireless receivers into the operator

  • How to properly set the hard stop

  • How to perform a learn cycle

  • How to connect a rocker switch

  • Technical differences of the 6100 & 8100

  • Display pad exit function

  • Rehanding

     

  • 115 VAC connection to swing doors

  • Wiring an electric strike

  • Header Mounting Heights

  • 6100/8100 Resetting Control

  • Fire Alarm Interface

  • Quick clamp trick to hanging a header

  • Remote/secure activation

  • Setting time delay

  • Opening Assist

  • How to set push n go

  • Locking Parameters

  • Control reset from display

  • Simultaneous Pairs

  • Swing door low energy mode with display

Swing Doors - HA7

  • Introduction to the HA7

  • Installing an Electric Strike

  • Installing a Key Fob

  • Setting the HA7 Mode Selector

  • Wiring a Wave to Open

Swing Doors - HA8-LP

  • Rehand an HA8-LP

  • Unboxing an HA8-LP

  • Installing an HA8-LP Header

  • Installing the spindle and arm on a HA8-LP

  • HA8-LP Hardware Packet

  • HA8-LP Incoming Power Connections

  • Wiring an activation device to the HA8-LP

  • Control Activations and Differences with the HA8-LP

  • Safety Inputs on the HA8-LP Explained

  • The HA8-LP On/Off/Hold Open Switch

  • Overload Pot Adjustment on the HA8-LP

  • Programming the HA8-LP

  • Adjusting Backcheck and Latchcheck on the HA8-LP

  • Factory Setting Default on the HA8-LP

  • 12/24 Volt Selection for Electric Locks on the HA8-LP

  • Electric Lock Interface on the HA8-LP

  • Setting Reed Switches on an HA8-LP

Swing Doors - HA9

  • Unboxing the HA9

  • Installing an HA9 Header

  • Incoming Power Connection on the HA9

  • Spindle Attachment on the HA9

  • Installing a Push Arm on an HA9

  • Installing a Switch on the HA9

  • Setting the Hard Stop on the HA9

  • The HA9 Learn Cycle

Sliding Doors - 5100

  • Using the display to program

  • How to wire a card reader on a 5100

  • Wiring a display into the control

  • 5100 Header Cover Tips

  • 5100 Anti-Riser Adjustment

  • Locking Out the Record Display Pad

  • 5100 Manual Mode

  • 5100 Change Partial Opening Setting from Display Pad

  • 5100 Open Stop Adjustment

  • 5100 Sway Rail Bottom Guide Adjustment

  • 5100 Series SX Panel Height Adjustment

  • 5100 Sliding Panel Installation on a Fixed Sidelite Unit

  • 5100 FSL - Sidelite Installation

  • 5100 FSL - Sway Rail Installation

  • 5100 Frame Assembly